Ask a specific question

GoldenMotor.com

deacon

minor bike philosopher
Jan 15, 2008
8,114
9
0
north carolina
I didn't get one either. My kit was so cheap I could bend the clutch lever with my hand. I didn't even put it on the bike.
 

nogoodnic

New Member
Jan 29, 2008
509
1
0
Shelby MI
forum1.freakbikenation.com
No problem Cruiser, I'm sure we'll get together and ride, man am I itchin' for a ride. the snow is almost melted enough to get into my storage shed, after that its a quick tune up, some warm gloves and away with the wind(^).

Deacon, I would not reccomend the stock clutch lever for anything more than scrap. I use locking Pyrimid brake levers, they are used on adult trikes and can be ordered at any LBS for between $10-15 a pair...Kelly
 

bgoates

New Member
Mar 3, 2008
85
0
0
What kind of speed are you guys getting with the stock Chinese 80cc kit and 44T sprocket ? I'm on a 24" bike and seem to be getting 20mph. Does a 26" make much difference ?

thanks
 

paul

Well-Known Member
Dec 23, 2007
5,547
44
48
66
Kalamazoo, MI
yes a bigger wheel makes a big difference. i am getting around 35 with a 40 tooth sprocket. when i had the 44 i was getting around 31 mph
 

Bikeguy Joe

Godfather of Motorized Bicycles
Jan 8, 2008
11,837
252
63
up north now
What kind of speed are you guys getting with the stock Chinese 80cc kit and 44T sprocket ? I'm on a 24" bike and seem to be getting 20mph. Does a 26" make much difference ?

thanks

There are those who swear it is not possible but I have seen 38-40 a couple of times on the flat, wide open. That was with a 44T, 26" 1.90 tires. Two different vehicles confirmed it. Not recommended.

I'm changing one to a 36T from thatsdax just to lower the cruise rpm.
 

sailor49618

New Member
Mar 29, 2008
5
0
0
I know that every now and then we have a questions that isn't urgent and doesn't require a long answer just a few simple words. So here you go my first question of that type.

Okay my engine is mounted almost perfectly vertical very little tilt. But some I have noticed are at about 45 degrees or more. So does that effect the carburator. If so how.
New to this.
I have a 70cc 2 cycle and bought a pull start for it but cannot get the nut and washer off the shaft in front of the magento because it keep's turning,tried holding the gear's but still turn's?
Do you know somebody that could help me.
Thank you.

sailor49618

[email protected]
 

Pablo

Master Bike Builder & Forum Sponsor
Dec 28, 2007
3,696
33
48
Duvall, WA PNW
www.sickbikeparts.com
Take spark plug out. Make sure piston is down a bit. Feed some clean flexible nylon or poly or whatever rope in spark plug hole. Turn engine now, until it tries to "compress" the rope. Rope trick.
 

sailor49618

New Member
Mar 29, 2008
5
0
0
Tried it and the shaft still turn's without the gear's or piston moving.
I cannot think of anything else to do but send it back??
 

sailor49618

New Member
Mar 29, 2008
5
0
0
Thank's for the welcome CRUISER.
Have tried just about all the trick's but no go.
Thank's again.^5
Sailor49618.