I have the Motor on the new frame and It's only on by 2 bolts and they are reinforced by cold weld stuff and I have the 3rd bolt with cold weld as well. I don't know if this will be enough to hold the motor safety but I will keep a eye on it.
Anyway, i found out the throttle cable has to much slack and I cannot move the throttle at all. I can't figure out how to remove the slack. I tried ajusting it where it goes into the carb and into the throttle grip itself..
Suggestions anyone ?
Anyway, i found out the throttle cable has to much slack and I cannot move the throttle at all. I can't figure out how to remove the slack. I tried ajusting it where it goes into the carb and into the throttle grip itself..
Suggestions anyone ?