Check out my video of my Schwinn Delmar cruiser bike built

[michaelbikin]

https://www.youtube.com/watch?v=VsFz0hjPx4s

Enjoy!

ps. does anyone think that my hub adapter is a problem, as there is a gap between the two pieces on the hub even though I have tightened them lots and lots. Thanks

Mike

 

[Chaz]

That gap makes it a perfect fit in my opinion,

Nice looking bike too.

 

[Tyler6357]

Good Job! The sprocket adapter looks fine, mine has had a small gap like that for 1400 miles although mine is a different type. Anyhow, just check it every so often to make sure that none of the bolts have vibrated loose. It looks ready for break in.

 

[michaelbikin]

Actually it is already broken in as I had used that engine on a different bike last summer for a few hundred miles, but I did notice that the adapter had some of the spokes bending around it as it wasn't centered between the spokes I checked and none of the spokes are loose and are all very tight and the wheel seems to be fairly true for the most part. Hope that doesn't become an issue

 

[Tyler6357]

Actually it is already broken in as I had used that engine on a different bike last summer for a few hundred miles, but I did notice that the adapter had some of the spokes bending around it as it wasn't centered between the spokes I checked and none of the spokes are loose and are all very tight and the wheel seems to be fairly true for the most part. Hope that doesn't become an issue

I guess just keep an eye on it, you might have to adjust it in the future.