Last week my bearings failed,
after five years of dependable use.
It failed quite probably from a
lean oil mixture.
I took the engine apart except
for the bearings and I can't seem
to find a decent bearing puller
that would fit.
However, I'm considering to order
a bottom end and re-assemble
the cylinder.
The engine is about five years old
and I think I ordered it from Kings.
I measured the diameter of the
cylinder to 48cc.
Is it worth the effort? or should
I just get a new kit?
after five years of dependable use.
It failed quite probably from a
lean oil mixture.
I took the engine apart except
for the bearings and I can't seem
to find a decent bearing puller
that would fit.
However, I'm considering to order
a bottom end and re-assemble
the cylinder.
The engine is about five years old
and I think I ordered it from Kings.
I measured the diameter of the
cylinder to 48cc.
Is it worth the effort? or should
I just get a new kit?