clutch help

  1. C

    HELP MY CLUTCH IS GONE

    Hello all, I a very new to this forum and just found out a way to post. I'll quickly get to the point. . . So, I was riding my newly built bike (that I've ridden around 1 and a 1/3 tanks) and I stopped the engine to go to the bathroom. When I returned and tried to start the motor by pedalling...
  2. I

    Clutch problem.

    i have a problem with my clutch slipping when trying to start my bike. It's a relatively new engine and probably shouldn't be doing what it's doing. The clutch does not slip when the bike is running. However when I let go of the clutch lever it will squeak and not grab and turn over the engine...
  3. O

    Clutch making strange noise while engine is idling [Video]

    Hello everybody, I'm pretty new in this community so please don't blame me too much :D So let's get started with the problems: When i start my engine and i pull in my clutch i start hearing some fast banging noise(not really sure how to call it) coming from the clutch plate side. And when I...
  4. C

    Help my clutch won't engage.

    I just bought a new motor for my stretch cruiser. It lasted a week. Went far to see a friend and before I got there my bike just went neutral. Upon checking I saw that the nut that holds the sprocket for the motor side chain was off. I tightened it back and it worked for half a block. Now I keep...
  5. bulldog87333

    Bicycle rolls freely when clutch lever is released

    Ok so first off I have read this thread (http://motorbicycling.com/showthread.php?t=22729) and tried everything on it. I'm sure the clutch cable is adjusted properly. I also tightened the flower nut completely so the clutch pads and plate were touching and it still rolls freely. I have had this...
  6. air250

    Need some help with clutch

    I am using a 3.5 hp B&S lawn mower motor that i had recently converted from a vertical shaft to a horizontal shaft. (which was not too bad) but i am now stuck on adding a clutch to the crank shaft so that the bike will b able to idle once i start it. Or maybe there in another way to make it idle...
  7. B

    Clutch too stiff to disengage

    First time installing...My clutch is so stiff/firm that there is no way my clutch cable and hand lever can pull back the clutch arm to disengage the clutch and allow the back wheel to spin freely. The only way i can disengage the clutch is with my hand and it takes alot of pressure to do so...