How to install cns carb??

Discussion in 'Intake & Exhaust' started by fischerking45, Feb 3, 2012.

  1. fischerking45

    fischerking45 New Member

    Joined:
    Jan 30, 2012
    Messages:
    7
    Likes Received:
    0
    Hi, I have a 66cc beach cruiser. Just got my new cns carburetor in the mail. Ok so attached to the carb are 3 transparent tubes. If somebody will please take a picture of how these tubes are supposed to be setup that would be amazing. If you can't take a picture then please explain it. Also, I do not have a choke cable for it. Can I just leave the choke opening as is or do I need to block it off? Thanks
     
  2. j3s

    j3s New Member

    Joined:
    Feb 2, 2012
    Messages:
    6
    Likes Received:
    0
    Hi. I have one also, after posting in introductions i did a search at yahoo and this is what i found.
    http://www.grubeeinc.com/USA/STARFIRE SKYHAWK WEB INSTRUCTIONS.htm

    down towards the bottom there is a few illustrations and says to leave disconnected and one tube is pointed down

    apparently they are high performance carbs

    jack
     
  3. Rage

    Rage New Member

    Joined:
    Aug 9, 2013
    Messages:
    6
    Likes Received:
    0
    I just put on my cns cone high performance carb and I can't get it to
    Stop leaking from the overflow ! What could b wrong?
    Do I have to have a slant mana fold?
     
  4. Rage

    Rage New Member

    Joined:
    Aug 9, 2013
    Messages:
    6
    Likes Received:
    0
    Also how do u adjust the air/fuel ?
     
  5. dodge dude94

    dodge dude94 New Member

    Joined:
    Jun 8, 2012
    Messages:
    1,017
    Likes Received:
    1
    You can't.
    You have to drill out the air idle screw and that helps. After that, if you're still running lean or rich, you'll have to rejet the carb.
     
  6. Rage

    Rage New Member

    Joined:
    Aug 9, 2013
    Messages:
    6
    Likes Received:
    0
    To what size do I drill it to? If that still doesn't work,
    What size jets do I get?
     
  7. Rage

    Rage New Member

    Joined:
    Aug 9, 2013
    Messages:
    6
    Likes Received:
    0
    Do u kno anything about the black expansion chamber
    exhaust, I.e, how to put it together ? Just got it and
    it is all in pieces . Didn't get instuctions.

    Can u help??
     

Share This Page