jet

I cannot find anywhere that sells NT carb jets in Canada and doesn't want like 30$ for shipping. I'm not spending around 50-60$ to get carb jets. I found these on amazon and I am wondering if they will fit my NT carb. I already have micro drill bits and a pin vise, along with everything to...

I replaced the stock nt with a good quality dellorto clone. Seems to idle well, maybe a little high. Sputters in mid range and bogs down bad top end. I've lost considerable power. Ideas? Too rich?

I recently switched from a CNS carb to an NT carb and although my overall performance has improved greatly, i still have a few issues. New ones. Firstly, when i first start up the bike and let it idle, all seams well, it idles at the right speed, and aside from a few missed power strokes, it...

A different kind of E-bike... Has anyone seen one of these? or thinking of building one of these? It looks like a 7 blade 120mm EDF unit - 6 units. Probably with a thrust power of around 10kg per EDF. http://www.youtube.com/watch?v=bDVcecoC_f0 A low power version of this. I think this...

Is anyone selling upgraded jets?I've been through MANY carbs, and went back to original. I cut a small circle from the bottom out of a pringles can and used a needle to poke a smaller intake hole. Pushes in to the jet with a pencil eraser...would rather have about a #71 jet. Any sellers...

I'm trying to decide between the Rawmotors.com Silver 66/80cc and the Jet 66/80cc from kingsmotorbikes.com, (both are 2-strokes). There isn't much to distinguish these two kits..at least from my point of view. They also both cost around the same, and are chinese made. Other Similarities...

I'm trying to decide between the Rawmotors.com Silver 66/80cc and the Jet 66/80cc from kingsmotorbikes.com, (both are 2-strokes). There isn't much to distinguish these two kits..at least from my point of view. They also both cost around the same, and are chinese made. Other Similarities...