Clutch proplem
- Thread starter Roy128
- Start date
3 prongs that sticks out is rubbing on my clutch plate????
Is this a 2cycle Engine kit? Could you take a pic?
Is this a 2cycle Engine kit? Could you take a pic?
I can't imagine what would cause this. First time for everything. I'll give you a link for clutch issues. In the meantime I'll step aside and someone who has had this problem will jump on.
https://motorbicycling.com/threads/...res-for-motorized-bicycles.22729/#post-215448
https://motorbicycling.com/threads/...res-for-motorized-bicycles.22729/#post-215448
Torque down the large center nut. If that's already tight?, remove the sprocket cover on the other side of the engine & torque down the large nut that holds the sprocket on. (Be very careful not to lose the small ball bearing that's down in the clutch pin hole)!!!!
If that doesn't fix the problem, you might be able to lightly tap the three pins down with a hammer.
If that doesn't fix the problem, you might be able to lightly tap the three pins down with a hammer.
Is this a new motor? Looks like foreign debris from (factory) assembly. those clutch pucks are .50 cents apiece. No doubt you will want a new plate. Also cheap enough. I don't know... Duane @ THATSDAX can set you up with parts. here about half way down the page. I hope you get it sorted. I'll be following along to see if anyone else have ever seen somthing like that.
http://thatsdax.com/ENGINE_KIT_PARTS_PAGE_3.html
http://thatsdax.com/ENGINE_KIT_PARTS_PAGE_3.html
Double check those bolts! (rotating parts are known to come loose even after being torqued)
