Will a slanted/regular motor fit a frame with these dimensions?

[alecwhardy]

I am looking for a RAW engine, but I am skeptical on if it will fit my frame. The dimensions of the frame are (top)18" x (bottom)22" x (height)11.5". I don't know if I should get a slant angle engine or a regular engine. I am looking here for my engine.

I have heard of that mounting it in the back is a possibility, does anyone have any instructions for that? Is that a kit I can buy or do i have to construct a stand? Thanks

 

[chainmaker]

Try this here..most engines are the same size, try looking at this http://motorbicycling.com/f30/engine-template-motorized-bicycle-25074.html#post232131 or post a pic or a link to the frame your planning on using.

 

[Cabinfever1977]

The best way to do it is get the engine kit then a bike.

 

[alecwhardy]

Here is the bike I am trying to apply the engine to. More info can be found here.

In the thumbnail below, I have measured the frame.
Yellow: 17"
Red: 12"
Blue: 18"
Green: 22"

 

[vincent713]

That frame is too small, the seat post frame should be at least 17 1/2 inch for clearance on the carb.