Separate names with a comma.
Discussion in '2 Stroke Bicycle Engines & Kits' started by doomedgame, Jan 22, 2018.
No update this week all my time went to my new hawk 250
How do you like it. I have seen them on ebay. Seems like a real deal. How is it on vibes?
Just got it together. It uses a big 230cc cg engine honda clone
Just did a first ride smother then the motorized bicycles i did not Rev high small yard but I like it.
The head and the plan
Comments and or questions are welcome!
Will be back working on the bicycle this set of days off head work. The hawk 250 can not be titled in GA so got the shaft on that one.
Big fat win!!!
well the stack of gaskets compressed more then expected so going to get some 4mm thick aluminum make a spacer this will be a little to thick but i can shave it down with the belt sander like the head this will cut me down to 2 base gaskets and a spacer
just ordered the plate to make a spacer
Had a little time close look at head
Well not likely to be a update on this someone stole the bike engine was not on it at the time
Sorry to hear that. I was looking forward to see you finish it. I was thinking about building one just like it only with case induction. I have the case already just need a crank and cylinder and piston.
Well I may finish it. Have not made up my mind if I want to. If I do will it will be a in frame tank bike
Well going to do it started ordering parts.
I"m glad your going to start over. I'm building a motor for my 5th board track racer but not sure what I'm going to do yet. I made the case already I'm not sure what to do with the cylinder yet? I wanted 48mm.
So your building a performance 2 stroke for a board track racer interested how you plan on doing a pipe.
I've already made the pipe. The bike is almost done. I just been too busy to finish it.
very well done fits the look well