replacing the stupid kit throttle

As long as it will fit a 7/8" handlebar, which is standard for most bicycles, you're good to go. Tell us how it works out for you after you've tried it.

Tom
 
2door said:
As long as it will fit a 7/8" handlebar, which is standard for most bicycles, you're good to go. Tell us how it works out for you after you've tried it.

Tom
Click to expand...

22mm is 7/8, looks like hes good to go :) not a bad find at all
 
It all depends on what throttle cable you have as unlike every other cable on our motorized bicycles the throttle has a fitting on each end, which means you can't cut the cable and if the length can't be adjusted to give you what is needed on the barrel end (~1") it will be too tight artificially setting idle too high, or too loose so you have a bunch of slop in your throttle action.

Your does not come with a cable so you will have to use yours.
SBP sales one with cable and options for like $19 here.
http://www.sickbikeparts.com/catalo...ucts_id=169&osCsid=6gt61i7u4rkrjdo95dtgdpuff0

I've used a couple, they work nice and the pulley it refers to is in the handle.
 
KCvale said:
It all depends on what throttle cable you have as unlike every other cable on our motorized bicycles the throttle has a fitting on each end, which means you can't cut the cable and if the length can't be adjusted to give you what is needed on the barrel end (~1") it will be too tight artificially setting idle too high, or too loose so you have a bunch of slop in your throttle action.

Your does not come with a cable so you will have to use yours.
SBP sales one with cable and options for like $19 here.
http://www.sickbikeparts.com/catalo...ucts_id=169&osCsid=6gt61i7u4rkrjdo95dtgdpuff0

I've used a couple, they work nice and the pulley it refers to is in the handle.
Click to expand...

I've looked at this throttle. The ad says it works with NT and CNS carbs. I'm planning on running another rt carb. So I can use this throttle just need to replace the cable?

Thanks, Dan.
 
Danschutz said:
Newb alert question!

What is the best way to add a kill switch if you go with this throttle upgrade?

Dan.
Click to expand...
My vote would be for any good quality normally open momentary switch. Mount it so it can be easily reached while keeping your hands on the grips. But that's just me.

Tom
 
So I finally received the throttle a month later. Cable was to short as I feared but I decided to try and dremel off the elbow to give me a little bit more length it works but I thinks its a tinny bit to tight gonna order a cable. I should of just ordered from sbp. What should I rejet my nt speed cab ( the red cap one) im at 218m elevation
 
You must log in or register to reply here.
Back
Top