Remove pullstart & centrifugal clutch?help!

[Cabinfever1977]

I have a 48cc Starfire GT-2 (GGG2) with pullstart and centrifugal clutch. It also has a manual clutch.

This engine is very wide and i have it mounted high so the peddals wont hit it.
I know that i could just get a wide peddal kit for $40-50, but i dont need the pullstart cause you can peddal 5 feet and the engine fires right up, and i dont use the centrifugal clutch,i always pull in my clutch when stoped.

So i would like to remove my pullstart, thats easy and just get a new $5 cover.

Next i would like to remove the centrifugal clutch:

This will require a new $5 cover, but do i also need to add a small gear and bolt? and what are they called and where to get them?

Karl

 

[Cabinfever1977]

Is this what i need: small beveled wheel?
GasBike - Crankshaft Parts Round Column Bolt

and if it, what bolt do i use?
O and do i need anything special to remove the centrifugal clutch like a gear puller or can i just use a socket wrench.

 

[Cabinfever1977]

You will need:

Round Column Bolt
Semicircular Bond
Small Bevel Wheel
Spring Gasket

You kit should have come with a tool to pull the centrifugal clutch off of the crankshaft, it looks like a long bolt with a thinner unthreaded end.

Thank you, i dont have the puller anymore, looks like i have to get that too.

 

[Cabinfever1977]

Its going to cost $33 plus shipping for my list of parts so i might as well get a whole bottom end for $64 with free shipping and then i can just add my head and stuff to that.

And yes i won't need the old bottom so i'll probally part it out.

 

[Cabinfever1977]

anybody know of a place thats cheap for a 48cc bottom end...

 

[Dooley863]

anybody know of a place thats cheap for a 48cc bottom end...

http://www.piratecycles1.com/