Modified Worksman Newsboy?

Discussion in 'Motorized Bicycle Welding, Fabrication and Paintin' started by cory151, Nov 6, 2011.

  1. cory151

    cory151 Member

    Joined:
    Oct 19, 2010
    Messages:
    466
    Likes Received:
    0
    Anybody ever removed or cut and modified the lower support bar on the Worksman INB to get more clearance for an (99ccHF) engine? Here is the bike Im talking about I guess I could always cut a slightly longer piece of round bar and contour it to mirror the top bar.

    Industrial Bicycles from Worksman Cycles
     
  2. thegnu

    thegnu New Member

    Joined:
    Sep 15, 2011
    Messages:
    982
    Likes Received:
    0
    why not ? check out mine its 4 bikes welded into 1 . I'll just be happier when its done .( not that I am not enjoying myself )
    Gary
     

    Attached Files:

  3. whitey

    whitey New Member

    Joined:
    Mar 7, 2010
    Messages:
    246
    Likes Received:
    0
  4. thegnu

    thegnu New Member

    Joined:
    Sep 15, 2011
    Messages:
    982
    Likes Received:
    0
    I thought that middle bar was structural support hasnt that frames integrity been weakened?
     
  5. whitey

    whitey New Member

    Joined:
    Mar 7, 2010
    Messages:
    246
    Likes Received:
    0
    not too sure about the structural support. You should message the builder
     
  6. cory151

    cory151 Member

    Joined:
    Oct 19, 2010
    Messages:
    466
    Likes Received:
    0
    I was thinking the same thing although Im admittedly not the cantilever frame expert.
     

Share This Page