Engine won't start

Discussion in 'Instructions for Building and Repairing Motorized ' started by Jacree, Jul 2, 2019.

  1. Jacree

    Jacree New Member

    Joined:
    Apr 22, 2019
    Messages:
    23
    Likes Received:
    3
    Hey everybody I was wondering if a dented output bearing seal would make my engine not run(dented during reassembly)...I have fuel and a have fire but it won't do anything, it won't even try to start..
    I haven't had to much experience with two stroke engines and I'm pretty much out of ideas... Any advice or pointers would be greatly appreciated
     
  2. Jacree

    Jacree New Member

    Joined:
    Apr 22, 2019
    Messages:
    23
    Likes Received:
    3
    Update- it's the clutch bearing that is dented so it shouldn't have anything to do with a leak... It has great compression, the plug has gas on it and it's sparking a nice hot blue spark... What am I missing, could I have bought a bad engine that would suck...
     
  3. Greg58

    Greg58 Well-Known Member

    Joined:
    May 1, 2011
    Messages:
    3,547
    Likes Received:
    509
    Did you put the magnet on backwards? It will fit both ways.
     
    FOG likes this.
  4. Greg58

    Greg58 Well-Known Member

    Joined:
    May 1, 2011
    Messages:
    3,547
    Likes Received:
    509
  5. Jacree

    Jacree New Member

    Joined:
    Apr 22, 2019
    Messages:
    23
    Likes Received:
    3

Share This Page