Alright, so i just ordered a 36 t Rear sprocket from Pirate cycles, and it only has 3 holes. I want to use the rag joint that uses 9 holes, but i don't know where to properly drill the holes.
The three holes in the 36 t sprocket are a bit bigger than the normal holes as well.
Does anyone have any mathematical suggestions on where to properly drill, or do i just follow the 44 t sprocket, and use that as a stencil?
Also, wouldn't the wheel or sprocket not work properly if it isn't drilled in the correct spots?
The three holes in the 36 t sprocket are a bit bigger than the normal holes as well.
Does anyone have any mathematical suggestions on where to properly drill, or do i just follow the 44 t sprocket, and use that as a stencil?
Also, wouldn't the wheel or sprocket not work properly if it isn't drilled in the correct spots?