This is a picture of the newest parts I have available it is a custom billet sprocket for the HD axle kits it is available 9 different colors this one is shown in midnight black. This is the pro-to type sprocket but all sprockets sold will have holes drilled in them and that will make them look more like a motorcycle sprocket. This bike has a 60 tooth sprocket they are available from 26 tooth to 80 tooth.
In this pic you can see the front drum brake I have had in stalled by my local bike shop they charge me $36 to build my wheels
I have 22 tooth pedal side sprockets but are not on my website yet and I also have 5 speed free wheel available with a dérailleur
In this pic I have modified the engine mount I will show pictures later of what was done but this mod will make it much easier to keep your drive chain tight. And what was done was the front and rear mount comes in three pieces I have sized the front and rear to match the frame and then I welded the front and rear together. This make it very easy to keep your chain tight with out a chain idler.
This a great product it is a 22 tooth pedal side sprocket works with the HD axle kit and makes it much easier to start out pedaling than with the original 18 tooth that you can get with the HD axle kit
Tanner will be getting this great looking glass fuel filter
Once you know your size of your mount placement you can add flat bar and weld the mounts ends together
These pictures show how much adjustment the engine mount has for keeping your chain tight
This picture clearly shows 1" 1/2 of adjustment that adds up to 3 inches of chain adjustment
This pic shows what you can do to clean up the look of your engine mount I have rounded all the square corners upgraded the bolts to grade 12 Allen heads, I do the same for every bolt nut and washer that come in these Chinese kits
I put this pic in a dumb place it should have come much earlier it shows how I got the measurements for the inch and a half
This pic shows the bike completely striped of everything 
This pic shows the access hole that has to be drilled to expose the un-welded joint at the extreme end of the top tube.
This pic shows the bottom hole that has been ground out to expose the un-welded seam where the top tube meets the bottom tube. You can see the material used for plugging the seam. You can also see the other two hole that are also plugged.
This shows the seat tube and the holes plugged one on each side.
This shows the extreme end and the hole for exposing the seam and you see the material used to plug it.
