Anyone Running The New Grubee 66cc Yet

My older motor didn't have the plate and I haven't had the mag out of the new one yet.
b46-pl-66_1.jpg

I bought a plate for the old one, figured the PO left it out. The older engine has the 6202 bearings.
 
looks like it uses the stator screws to hold it in - my motors all have stators that fit pretty tight over the raised alignment boss cast into the case, does your case have that boss?
 
Looks like with out R&Ring the mag it fits over the mags bosses and is held in place by the laminations.

Someone went to a bit of trouble to add it, so they must have thought it necessary.
Looks like it might also catch shavings to keep out of the seal if there was any contact of the rotor with the mag. I have seen slight contact before.
 
I think this is just a seal retainer due to the thin nature of this side`s seal.
b46-pl-66_1.jpg

The plate is held in place with its own screws.
The older engine without the plate still has the boss for it and is drilled tapped for it.

Steve
 
seated properly on the case-boss, the rotor has about 8thou clearance - only seen contact when stator wasn't seated properly or when mains had gone bad letting crank move up/down

boss is a pretty tight fit, so if I see one of these, I may have to consider grinding the stator a bit to be sure of good centering

I'm wondering if the case boss was left out when these are used.
 
You must log in or register to reply here.
Back
Top