62cc engine help!!

K

Kinsaka

New Member
Apparently I put in a link in my post.

I installed a 62cc engine from DAX. Everything's installed, unfortunately It seems I can no longer pedal the bike. Any help? Also does the gas tank need to be over the engine or can I mount it behind the engine on my bike rack.
 
You need to pull in and lock the clutch in order to pedal. Your tank can go on the rack but make sure that the bottom of the tank is higher than the carb. the engines are gravity fed so if the bottom of the tank is your at or below the carb, you wont get fuel.
 
even when I lock the clutch it seems the the wheel wont turn, should it turn freely like im in neutral on my truck?
 
Yes an no. There will be friction and if you are trying to turn the sprocket by hand it will be very tough. With the clutch pulled in and locked, push the clutch actuator further towards the engine and try to roll the bike. Perhaps its not adjusted properly. When adjusted right it is like neutral but a bit more friction.
 
I have a GasBike kit and there is no way to adjust the clutch to free-wheel. If you do adjust the clutch to free wheel then the clutch slips. I have contacted GasBike but can not get a reply back. I talked a friend into getting one and he has the same problem. Once under way he adj. the clutch while riding. Must be a better way. Vic
 
I think Im going to actually get another bike to mount the engine on, as the gas tank is no way going to over the engine. As for the clutch how would i get it adjusted for it free wheel without it slipping?
 
You must log in or register to reply here.
Back
Top