i had one of my adaps i was talking about earlier in this thread that didnt fit was off by .5mm enough to slip lucky for me i have a nice tig welder and i welded it to the hub proper lol took me 3 mos to get it didnt have 6 to waste
This is priceless!!!
- Thread starter Creative Engineering
- Start date
Neat Times...yes I think being a dentist is not that hard of a job..does not take a whole lot of practice or skill...I had a tooth on the bottom in the back of my mouth giving me problems for months..after using that "Numbs-it" salve on it for two months decided to pull it out one night in the garage...mirror,good light, sixpac of beer couple shots of Canadian Club, small vice grips with a little tape on the jaws and a little cursing...Job Done...little bleeding but packed it with gauze and went to bed...wife was mad about the blood all over her new pillowcases and sheets
Last edited:
I actually have done that more than once.....lol. I added a few things to my medicine chest first though. Big green sticky smelly tobacco like substances....haha. I did not do as good of a job as a dentist might as I still have a few fragments on a couple of the molars that will need to be taken care of one day. Teeth are easy to break with pliers.
You can spend a little more time and work them loose with your fingers. Sometimes it is good to wash hands afterwards! Lol
one of my uncle`s had a bad tooth problem. The dentist was a retired navy dentist. He suggested they go to bar for a drink. Didn`t make it back to the office!! I remember the dentist, he used to come into my bar. Funny looking little fellow. Around 1970.
Hope were not ot. Lol
ron
one of my uncle`s had a bad tooth problem. The dentist was a retired navy dentist. He suggested they go to bar for a drink. Didn`t make it back to the office!! I remember the dentist, he used to come into my bar. Funny looking little fellow. Around 1970.
Hope were not ot. Lol
ron