starting problems plz help

K

kutsuda

New Member
hi guys my bike build is finally done bike runs great but when i stop the engine still wants to pull a bit and when i pull in clutch the engine stops when i stop as long as i go a few mph the bike runs fine until i make a complete stop it wont idle and vibrates a little while wanting to go foward does anyone know whats up ?
 
Yes, Loosen the clutch cable end and push the arm over a bit more then re-tighten. Or- turn your cable adjuster out at the lever to take up some slack in the cable.
 
It sounds like your clutch is not completely disengaging when you pull the clutch lever. Try tightening up the cable on the engine side. In other words remove any slack there is in the cable. Then you should be able to pull the clutch lever and have it completely disengage and it will no longer die or try to move forward.
 
thanks alot guys after tinkering around a bit i finally got it running right had to make clutch lever really tight and adjust cable i also had to increase idle a little now its running good
 
You must log in or register to reply here.
Back
Top