Runnermike's Dyno Build
- Thread starter runnermike
- Start date
Yea!I just read about all this hope you guys are nice and healthy cancer-free good to see things are going great for you. Not build that 4 Stroker
Well...I have finally figured out my front end set up. I have a set of DNM USD-8 DH forks coming and a dual disc hub. I will be running two 203mm rotors up front with hydraulic brakes. I found a set of pit bike twin hydraulic calipers with a splitter. Center hole to center hole on the calipers is 48mm, so....I will need to fabricate my own brackets/adapters. I was hoping I could make the one from AGK work, but the holes on that bracket only measure 44mm...so Hooray I get to fabricate!
I tried posting pictures...lets see if I remembered how to do it!
I tried posting pictures...lets see if I remembered how to do it!
Attachments
I am also going to need to extend the rear dropouts due to how I have my seat. Not sure exactly how I will accomplish this, but I am sure I will figure something out.
Attachments
Oh how nice those look, stepping up that game I see. I am excited for this build.
The forks and hub arrived. Now I am just waiting on the rear hub and wheels to show up. Once that happens, I can lace up wheels and hubs, and get the bike sitting how I want it. Then, I can fabricate and finish the build. My goal is to have it complete by my birthday in February so I can take it to the races at Daytona.
Attachments
Still waiting on my felt wheels to show up. I contacted the shipper today and he said he should receive them from felt this week so hopefully I will have them by next week.....the waiting is killing me!
Is it just me, or are some bicycle vendors extremely slow. I am very impatient though!