Retraction - Didn't realize I had dissed CH80

GoldenMotor.com
Status
Not open for further replies.

chrisnbush

New Member
Jan 10, 2008
41
0
0
Richmond, NH
I am cross posting this here
*********************

I have a couple of posts on both forums, where I describe my problems with upper bearings / gaskets / etc. with 2 cycle center mounts, typical NUB stuff (thats me).

I just started this stuff a year ago and I am having a blast. I had collected a list of websites of suppliers, but I had always thought "CH80" was just shorthand for "Chinese 80CC" engine in general. So I used it in a lot of my posts.

My apologies to Chris, and I suspect his product might be a good one, as much as it is referenced everywhere. I am now excited to check it out.

Here is a little story, to understand who you are dealing with here. I was in school and registering for classes. A lot of the classes were taught by someone named "Staff", and I asked my buddies who Professor Staff was. Space cadet.

rotfl
 
Status
Not open for further replies.