replaced that clutch from old 66cc that was not working.

[gill vanderwerf]

i finally got that last part in that they forgot to send with that replacement clutch kit, took me a wile to figure out how to put it together but when i got it all done the cap did not fit right on where the bucking bar is , had to use a little force to get it bolted in and when i moved the are for the clutch it was working it lifted the other side, but then one of the screw hols snapped of from the tension it seems that the bucking bar is too long i dont get that should this not just fit.....and can i use a bench grinder to shorten it a bit?

 

[allen standley]

Did you replace the Ball behind the bucking bar?

 

[gill vanderwerf]

yes i did that also

 

[gill vanderwerf]

got a whole new set had everything with it

 

[allen standley]

Did you remove the old ball stuck inside with grease? If not- that may be the reason why buck bar seems too long.

 

[gill vanderwerf]

got it done ....the motor is working..gave myself a big pat on the back.. 1st time i ever done anything like this. running the motor right now with a 8oz per gallon mixture need to break it in slowly only ride 20 min then let it completely cool off and ride another 20 min. its a pretty wicked motor