rear engine chain mount 79cc thoughts ?

S

Scott M

New Member
Hello,
new guy here. I restored 2 1980's Peugeot mopeds and have a Vespa ET50 but now I am interested in a motorbicycle. I have a tandem bike in the garage that is calling out for a predator engine. I have seen a few builds that put the motor in the rear frame area. My question is about trying a rear frame chain drive mount . I currently have a child seat mounted in the back and have had grandbabies in it that weigh more than an engine and have no control issues. anyone have any thoughts on the issue ?

thanks,
Scott
 
I have built a few rear mounted bikes one a 79cc HF engine another 98cc Lifan and found no issues other than having to get you leg up and over the engine getting on. May not be an issue with a tandem.
 
cannonball2 said:
I have built a few rear mounted bikes one a 79cc HF engine another 98cc Lifan and found no issues other than having to get you leg up and over the engine getting on. May not be an issue with a tandem.
Click to expand...

That and the center of gravity was not my thing. It raised the center of gravity of the entire bike,
 
I agree the CG is pretty high but you get used to it.

You will probably need a jackshaft as its on a tandem, a lower ratio would be good. Maybe a 16-20:1 depending on loading and hills if any. We have two tandems and I have been resisting powering one of them. There is one on YouTube the has a 212 cobbled into the frame.
 
yes. I saw that. Its quite a ride. I currently have a kid seat in the back so I am use to the weight back there. The cross bars are low so its easier to get the legs through. Thanks for the replies.
 
You must log in or register to reply here.
Back
Top