motor wont fit .. help =(

Discussion in 'Motorized Bicycle General Discussion' started by Kraash, Sep 22, 2008.

  1. Kraash

    Kraash New Member

    Joined:
    Jul 29, 2008
    Messages:
    44
    Likes Received:
    0
    i just got my 'thatsdax' motor in the mail and the 2 front bolts are to close togeather to go around the slightly fat front lower tube... any idea? =\
     
  2. jburr36

    jburr36 Member

    Joined:
    Jul 17, 2008
    Messages:
    284
    Likes Received:
    0
    Ask Dax for the Big tube frame adapter or you can craft your own. I had the same issue and it was a simple fix.
     
  3. OSCAR383

    OSCAR383 New Member

    Joined:
    Jul 22, 2008
    Messages:
    243
    Likes Received:
    0
    THERES AN ADAPTER PLATE . IT WILL BE RECTANGULAR AND HAVE THREE HOLES USE PLIERS TO REMOVE STUDS AND BOLT PLATE IN WITH THE LONG BOLT POINTING OUT THE OTHER WAY. DRILL A HOLE IN THE LOWER TUBE PUT LONG BOLT THRU AND USE LOCKING NUT ON BOLT END THAT STICKS THRU THE BOTTOM OF FRAME.

    OR IF YOU HAVE TIME TO MAKE IT LOOK NICE TAKE A ROUND PUNCH AND A HAMMER . MARK WHERE YOUR BOLTS WILL BE . AND MAKE A TRENCH ON EACH SIDE OF TUBE UNTIL ENGINE STUDS WILL CLEAR.

    HOPE THIS HELPS
     
  4. Saddletramp1200

    Saddletramp1200 Custom MB Buiilder

    Joined:
    May 7, 2008
    Messages:
    1,420
    Likes Received:
    0
    You Da' MAN! Solved my issue with the point beach build! U clamps ROCK :) Now for that electric start rotfl
     

Share This Page