How used a Oil to Gas Mixing Container?

[cj200]

How do i used a Oil to Gas Mixing Container?
this my first time doing this.

i was going to get this Oil to Gas Mixing Container but im unsure how it works

i was going to used 2.5 l Of gas

can some tell me how used the Oil to Gas Mixing Container

please

http://canadiantire.circulaires.com...07P/Oil+to+Gas+Mixing+Container.jsp?locale=en

 

[rustycase]

Determine which ratio you wish to use.
Select that column near the top of the bottle.

Go down the column for the measurement of gasoline you have available.
Fill the bottle with your oil to that line.

Pour that measured amount of pre-mix oil into your container of gasoline.

You might wish to pour a bit of gas into the measuring container, and rinse it out, back into the gas can.

Slosh your container of mixed gas/oil around for a minute to assure it is mixed well.

Ready to go.

Best to use a funnel when filling the tank, and have a clean rag handy.
Only fill your tank halfway.
A little bit goes a long way.
Too much might slosh over.

Good luck
rc

 

[cj200]

thank you for you help

one more question

the Oil to Gas Mixing Container is only
Determines ratios for 100:1, 50:1, 24:1 and 10:1 mixes

will 24:1 be all right to break the engine in?

 

[rustycase]

24:1 should be just fine with any reasonably quality oil.

Regardless of the oil, IMO, best to take it easy on the new motor until it is broken in. No big hills, no races, no long extended runs.

Good luck
rc

 

[cj200]

thank you so much for the help

could tell if any of this oils are good enough
because that all is sold here in Newfoundland that i can find.


Link 1

or this one link 2
or

Link 3


Thanks for the help.

 

[Bikeguy Joe]

I would go with number 2.

 

[cj200]

thanks................................................