Honda Gx160/200 Gearbox

[BigBlue]

FYI,

found this seller on Ebay selling 2:1 gear reduction boxes for some Honda GX160/200 engines. I underlined "some" because it only works with specific types of engines. I would carefully read the item description to see if it would work with your application

http://www.ebay.com/itm/35048945637...X:IT&_trksid=p3984.m1438.l2649#ht_1161wt_1185

Good Luck

Chris
AKA: BigBlue

 

[scotto-]

Wow, almost $300 with shipping.......that's a little steep in my book. I'm not so sure that set-up would work on a motorized bike judging by where the output shaft is located?

But thanks for sharing this info.....

 

[foundmydog]

you figure a GC160 is 11 or 12 inches wide plus another 2 to 4 inches for that gearbox would make for one very wide stance!

 

[wayne z]

you figure a GC160 is 11 or 12 inches wide plus another 2 to 4 inches for that gearbox would make for one very wide stance!

And you would still need a jackshaft for ratio and chain alignment. Now if they made one with the output on the opposite side, we could prolly work with it by using a large sprocket or sheave on the wheel.

 

[cannonball2]

Ive got one of those that was on a clone engine a friend gave me. He runs concession karts with these units. Says the boxes out last the engines. Its a pretty cool setup with the wet cent clutch, looks well built. But is BIG.