Here I go again,Briggs build

Discussion in 'Motorized Bicycle Welding, Fabrication and Paintin' started by scratchbuilder, Dec 11, 2015.

  1. scratchbuilder

    Joined:
    Jan 17, 2015
    Messages:
    559
    Likes Received:
    6
    Hey Curt, if I get what your saying, I could put a flat bar above my 6" pulley, which would keep the beltfrom loosening there, instead of where I need it to loosen, at the engine. When first starting up, I need to put the bike on the kickS and fire it up. Once it is warm up the belt loosens enough to sit and start. And if I adjust my lever, then it slips under power. Dang I see that solving the problemoe!! Thx
     
  2. scratchbuilder

    Joined:
    Jan 17, 2015
    Messages:
    559
    Likes Received:
    6
    Dang, I think I jacked my own thread....
     
  3. curtisfox

    curtisfox Well-Known Member

    Joined:
    Dec 29, 2008
    Messages:
    4,007
    Likes Received:
    31
  4. curtisfox

    curtisfox Well-Known Member

    Joined:
    Dec 29, 2008
    Messages:
    4,007
    Likes Received:
    31

Share This Page