GT2A with monark 2 forks?

D

dumpstercrusher

New Member
Anyone running the GT2A frame with monark 2 forks? I need to start ordering parts for the new build, but don't know if the monark 2 forks would fit this frame with no modifications. If they don't fit with out modifications then which springer forks would work? I'm also going to guess that all GT2A style frames are the same at the head?
 
http://motorbicycling.com/album.php?albumid=1188&pictureid=7400


there ya go
the shims arent the problem with using these forks , its the length of the steerer tube
the head tube on this frame is enormous & the tube just fits thru
i had a machinist make a 2 piece (top & bottom) , head set reducer & bearing race , that would press flush with the head tube
he also machined an o ring into them so they are sealed too
 
Last edited:
wing nut said:
http://motorbicycling.com/album.php?albumid=1188&pictureid=7400


there ya go
the shims arent the problem with using these forks , its the length of the steerer tube
the head tube on this frame is enormous & the tube just fits thru
i had a machinist make a 2 piece (top & bottom) , head set reducer & bearing race , that would press flush with the head tube
he also machined an o ring into them so they are sealed too
Click to expand...

how long is the steerer tube and the part where the monark forks fit thru? so in order for me to run this set up id have to get a machinist make me peices to get this setup to work properly?
 
You must log in or register to reply here.
Back
Top