Got a New bike

Suh Weet!
Now if you need info, just don't fall for the guy who sends you free info for 25 dollars from texas....

You will of course make a new roller for it with a skate board wheel.
 
Be careful when putting it on the side stand and walking away, they have a tendency to tip over if not set just right.
 
Bikeguy Joe said:
Be careful when putting it on the side stand and walking away, they have a tendency to tip over if not set just right.
Click to expand...

Bikeguy Joe said:
Suh Weet!
Now if you need info, just don't fall for the guy who sends you free info for 25 dollars from texas....

You will of course make a new roller for it with a skate board wheel.
Click to expand...
yep, it Falls over easily if Not placed right!
Skateboard wheel roller.... Sounds good because the normal roller slips a lot..going to go for I ride now c'ya!!!dance1
 
Use the adjustment rod to make the roller run on the tire with enough pressure. If the "teeth" are worn off the roller, a skate wheel replacement is due. It's not too hard to do either. You can gain a few mile per hour top speed once the roller has been replaced.
 
Yesterday I replaced the front wheel. The thing is. I rode an it worked fine. It was wet yesterday so........ Agh I'll just replace the roller! :)
 
When it's dry, it starts. But when I hit the trottle, it goesand then slows down. I assume this is the sparkplug. I'll have to get a new one.

But when it's wet, the roller dosent grip the tire. Again, I need to replace the roller with a skateboard wheel.

Ohhh this is sooooo much fun laff
 
Did you clean the felt fuel filter that is at the end of the line inside the tank?

I think I mentioned that before, it will cure your running problem.
 
You must log in or register to reply here.
Back
Top