Four Questions

Padanew

New Member
May 9, 2008
17
0
0
How do you start the engine? I have an idea how it starts just not sure. Is it a battery start or a pull start or do you start it by pedaling?

Also, has anyone used a gas tank sealer before? For example like KREEM gas tank sealer kit. Is it a good or bad idea?
 

Dave31

Active Member
Mar 1, 2008
11,204
29
38
Aztlán, Arizona
You just pull your clutch in, pedal and gather some speed (I usually start mine between 7-10mph) let your clutch go and vrooooommmmm you are on your way. They do not have battery's..... There are some pull start kit's that you can buy, but it is so easy to start for me I don't see a need.
I have never used a gas tank sealer.:ride2:
 
Last edited:

deacon

minor bike philosopher
Jan 15, 2008
8,117
3
0
north carolina
When I drop my clutch I have to keep pedaling about three or four more turns to make it start. when it was new I just dropped the clutch and it started now I have to work just a bit harder not enough to pay money to start it. After the first time each morning it starts with the drop of the clutch instantly almost.

Never used a sealant. The beauty of these engines for me is that they don't need any internal work. they are cheap enough that I doubt I would do anything more major than put a set of rings in. If the bearing knocks it's on to a new engine for me.

Now not so the bike and bolts holding it to the bike. they need a lot of attention
 
Last edited: