Mopedamauter79
New Member
So one day I go to get on my bike after it was sitting untouched in the living room and I use the throttle and nothing happens. I checked to make sure there was enough power coming from the battery and there is. I checked all the wires and I was able to figure out that there is power going into the controller but I was not able to get a reading coming out of the controller going to the motor.
so I take it down to get fixed and this is a very big tassel for me as it takes 3 hours round trip by bus to get to the repair shop. It's also a large pain to get a ride down there as well. So that's fine. It gets fixed and I'm told the controller was dead.
So I bring it home with no problems and I even used it the next day as well with no problems. I go to get on it today and the same problem. The motor doesn't respond when I use the throttle. So it's sounding like the controller once again is dead. Either I have very bad luck and the controller being a used one was not up to par and was on it's last legs. The only other thing I can think of is something is causing the controller to fry and I don't know what this could be. I know they had problems with the kill switch at first but they replaced it so I was told..
I'm really at my wits end. Not only is this going to cost me more money but it's a royal pain in the but for me to go down to the shop to get it fixed!!!
grrrrrrrr
so I take it down to get fixed and this is a very big tassel for me as it takes 3 hours round trip by bus to get to the repair shop. It's also a large pain to get a ride down there as well. So that's fine. It gets fixed and I'm told the controller was dead.
So I bring it home with no problems and I even used it the next day as well with no problems. I go to get on it today and the same problem. The motor doesn't respond when I use the throttle. So it's sounding like the controller once again is dead. Either I have very bad luck and the controller being a used one was not up to par and was on it's last legs. The only other thing I can think of is something is causing the controller to fry and I don't know what this could be. I know they had problems with the kill switch at first but they replaced it so I was told..
I'm really at my wits end. Not only is this going to cost me more money but it's a royal pain in the but for me to go down to the shop to get it fixed!!!
grrrrrrrr