Boardtracker saddle

I think just about any vintage sprung saddle or a Brooks type seat would look fine? Oddly, a vintage saddle would prolly be far cheaper than a Brooks... if ya can dig one up lol

1021478_article_img_large4.jpg


Brooks B17 Standard Saddle, I think it's the base model @ "only" $70ish heh;
qElUwV2r4zMLfrlYfqCCFUjjXNF3pVJJTgY.jpg


If yer lookin' to save a few bucks, check Google Product Search with some keywords like "vintage style bicycle saddle" - there's some neat stuff :)
 
Last edited:
Thats it.. Pretty Sweet !!! Sent a message to SportsCarpat about his layback post (if hes still making em) for it. Its super dark brown pretty close to black.
Cheers
Chainmaker
 
bangbang880 said:
just wondering the tilt/lean on your layback seat post? Is there a photo up I can look at?


Thanks!
Click to expand...
Typical seat post/frame tube angle is around 23 degrees back from the vertical, then from there I run the layback part horizontal. This gives a 113 degree between the two sections of the seat post. I can make different angles as well, just let me know what you need. Here is a picture.
DSC05153.jpg


DSC05375.jpg
 
with one of those "hairpin" seats like the one pictured above, the springs and rails will get in the way of the vertical post, so it'll limit the amount of "laid-backness" you'll get out of it.

i had the same type of seat on my copper bike, and i think i could only get about 3" back from normal, maybe less.
 
i found a pic to explain:

20661d1266697470-1930s-colson-motor-bike-my-new-done2-20-10-004.jpg


i like to run my seat clamps turned upside down so they don't show as much, so if you ran it normal it'd give you a little more room.

or if Pat welded up a pipe that was closer to a 45 (dunno the exact angle, you could figure it out when you get the seat) then the vertical post would be underneath the rails more.

or maybe a "Z" shape?
 
I am going to wait until I get the seat and see how it fits Me and the bike.Before I decide on the post
Cheers
Chainmaker
 
Here is the intended victim..just waiting for the springer forks to come back,MM mount, and a couple other parts. I was going to use it as a daily but I think Im going to sell it, to fund a Vintage Panther or a Worksman.
Cheers
Chainmaker
0709001515.jpg
[/IMG]
 
The New seat came today here's how it looks. Going to go with a 3 1/2 in lay-back post.
0714001958.jpg
[/IMG]

Cheers
Chainmaker
 
You must log in or register to reply here.
Back
Top