Another beginner

Discussion in 'Introduce Yourself' started by jhicks90, Aug 7, 2017.

  1. jhicks90

    jhicks90 New Member

    Joined:
    Jul 29, 2017
    Messages:
    3
    Likes Received:
    0
    Hi everyone, my name is Jason. Just finished my first build about a week ago. I have about 1 mile on it as I have run into a little trouble with the bike brakes. I finally got them straightened out. Now it seems like even with the clutch engaged every tire revolution or so it seems like the piston is moving. Could I need to tighten the clutch cable? If so do I just loosen the screw and pull it out a bit more? Will it hurt the motor if riding like this? I apologize in advance for not knowing the first thing about this stuff. Any help would be greatly appreciated.
     
  2. Chaz

    Chaz Active Member

    Joined:
    Jun 3, 2012
    Messages:
    910
    Likes Received:
    36
  3. jhicks90

    jhicks90 New Member

    Joined:
    Jul 29, 2017
    Messages:
    3
    Likes Received:
    0
    Thanks Chaz I will check it out
     
  4. jhicks90

    jhicks90 New Member

    Joined:
    Jul 29, 2017
    Messages:
    3
    Likes Received:
    0
    It ended up being the cover the clutch arm comes out of. One of the screws was loose and that caused the issue. Tightened it and it now rolls great.
     
  5. Chaz

    Chaz Active Member

    Joined:
    Jun 3, 2012
    Messages:
    910
    Likes Received:
    36
    I like good news!

    Have fun.
     

Share This Page