Best mounting on aluminum frame?

Slightly different application, same concept

I took a chunk o'pipe w/the same ID as my bike's tubing OD and cut it in half, grinding a bit of a taper to fit in the U bolt, I later added a tack weld to hold the steel "pad" to the U;



That outa diffuse the crimping force of the U bolt quite nicely

tim dont do what i did....but it works great...here it is..any? just ask...simular to barely awake...and the finished product...could have been better but i made a big mistake in the beginning...good luck...Dennis

Nice build doc!
Does the mufflers quiet down the expansion chamber noise?
I wondered why you mounted so high until I seen why, very clever.

believe me, i didnt want to mount so high....the first mounts were great but they failed so instead of dumping the whole thing, i went to plan B....worked out ok...yes the sound on this bike is sweat...not load, just clean....if i remeber the mufflers, chamber and pipe were 40 dollars off of e-bay...my other bike has the single muffler set-up and it also has a clean sound....the chambers kick-in around 15-20mph depending how hard i ride it...for the money...lot better than stock...this is a triple butted aluminum gary fisher...and i went thru the frame and treaded on the inside of the mounts...thanks for the look see and i hope this helps with any problems...Dennis