Throttle?

[jmr3394]

Is there any other way to attach throttle without drilling? And my kill switch has two wires. where do i connect them to?

 

[Bikeguy Joe]

I never drill, just pull that pin out.
I also don't use the notoriously bad kill switch.

 

[jmr3394]

so how to you kill the engine? stall?

 

[wheelbender6]

You can buy a kill switch at a shop that sells quad or powersports parts.
I used an old mountain bike thumb shifter for a throttle. It allows you to adjust the idle speed from the handlebars and the friction knob serves as a cheapo cruise control.

 

[tomahawk]

I installed my throttle/kill switch only to have that plastic pin shear off immediately...worthless. What i did was use the same grip only put sandpaper in between where the pin was and tighten down. Problem solved.

 

[Noped]

I was unaware of the "pin" inside the grubee kit twist grip and it broke when i forced the clamp together and the screws seemed to be holding it without the pin. the sandpaper idea sounds good; my problem now is that the twist will not move the cable; it's broken. Has anyone taken these china cheap things apart and can i fix mine?
I do like the kill switch! I took the red on/off and oil sensor off my honda gxh and plugged the kill into the coil, grounded and it works well so far; i would like to fix the throttle part and use it for at least more than one day )-:

 

[TheE]

Yeah, that little plastic pin is junk, just drive a good sized screw through there instead.

 

[maximillian]

Thats exactly what i did, i screwed a screw through where the pin broke off into a hole i drilled in the handlebars