Suggestions for 4-stroke motor mount for OCC Stingray?

AmericanGasBikes

AmericanGasBikes

New Member
A person recently approached me wondering if there are motor mounts for 4-stroke kits for the OCC Schwinn stingray. I've looked around online and obviously found nothing. I've seen a couple photos of other's Chopper builds with 4-strokes installed, but couldn't see what method others were using to install the kit.

Any Suggestions?
 
Build a mount similar to the HT mount but install a flat plate on top rather than ht mounts.
 
If this is not a potential customer/sales build, I would suggest that you invite this person to do their own research on the subject.
 
@maniac57 Thanks for the tip

@bigbutterbean As a matter of fact I did. For future reference though I had to inquire myself, in case someone else asked later.

Much obliged fellow Motorheads!
 
A piece of flat plate welded to the bottom tube will be fine. You will run into chain routing issues if you are keeping the pedals unless it's a small 4 stroke like a HS
 
You must log in or register to reply here.
Back
Top