Problems mounting EZ Motorbike in Panther frame..

Discussion in 'Board Trackers and Vintage Motorized Bicycles' started by Master Link, Jun 12, 2018.

  1. Master Link

    Master Link New Member

    Joined:
    Apr 7, 2016
    Messages:
    13
    Likes Received:
    0
    Anybody experience problems mounting ez motorbike kit in 50s Schwinn Panther frame? Will call Quentin tomorrow but I know many people here on forums have done it. Maybe I just got a bad mounting plate? Any pictures would be helpful.

    Thanks.
     
  2. Master Link

    Master Link New Member

    Joined:
    Apr 7, 2016
    Messages:
    13
    Likes Received:
    0
    Also any tips on supporting transmission to frame downtube. Again pictures would be helpful.

    Thanks guys
     
  3. Master Link

    Master Link New Member

    Joined:
    Apr 7, 2016
    Messages:
    13
    Likes Received:
    0
    My instructions say to mount long engine support block forward and short one to the rear. Humm maybe that's the problem mine are both the same size. I'll find out more tomorrow when I talke to Quentin. Just got kit today maybe just trying too hard need rest. I'm sure just need to drill new mount holes and mount engine right up to the front end of mounting plate, should be ok.
     
    #3 Master Link, Jun 12, 2018
    Last edited: Jun 19, 2018

Share This Page