Hello everyone my problem is the bike wont start back up it wont pump it's a new motor I road it around the block and it cut off I loosened cable & adjusted it no action . I have another bike like this one I've road 4 awhile & then I let some one ride now its doing the samething as the new one no pump action please any one HELP!
No Compression No Resistance
- Thread starter DRE DAE'
- Start date
Bikeguy Joe
Godfather of Motorized Bicycles
So you are saying your clutch is slipping?
Bikeguy Joe
Godfather of Motorized Bicycles
What happens when you disconnect the cable?
Have you turned the "flower nut" or made any other "adjustments"?
Have you turned the "flower nut" or made any other "adjustments"?
Bikeguy Joe
Godfather of Motorized Bicycles
O.K., I just read in your OTHER THREAD about this that you unhooked the cable and it still slips.
Take the cover off, and use some carb or brake cleaner, and clean the clutch plate and those little "pucks" and try it. It should solve your problem.
Are you IN Cleveland, or outside it somewhere? I am waaaaya out here on the "east side".
Take the cover off, and use some carb or brake cleaner, and clean the clutch plate and those little "pucks" and try it. It should solve your problem.
Are you IN Cleveland, or outside it somewhere? I am waaaaya out here on the "east side".
Bikeguy Joe
Godfather of Motorized Bicycles
Keep us post as to how it goes.
Yes, you are on the east side, I am, as I said "waaaay east". Still you are only an hour drive if you can't figure it out. Let me know.
Yes, you are on the east side, I am, as I said "waaaay east". Still you are only an hour drive if you can't figure it out. Let me know.