new bgf bad head or jug?

[beentryin]

i bought a bgf 66 off ebay about a month or two ago,and just recently got my wifes three wheeler frame done,and put the motor on,it started at first,ran pretty good turned it off,let it sit a few, and retourged the head ,which was pretty loose,tryed to start it.and it back fired or popped and would only fire every once in awhile.so i pulled the head and noticed it spitting fuel and oil out of between the head.so i put my spare head gasket on it ,it fired rite up and then popped,and when it trys to fire it makes the typical head gasket squeak ,pulled it back off and sure enough oil comming out of between the head? this is a brand new motor any suggestions on how to fix this?thanks in advance

 

[corgi1]

Do you need to use a piece of sandpaper laying on a sheet of glass and level out the warping of the head?,,,should be threads on this on the search bar at the top of the page

 

[Ted]

My money is on the head also, sand it in circular motions.

 

[skyhawkcannondale]

That sucks tommy,, it ran great the other day.

 

[beentryin]

well i got it to run i lapped the head and the cylinder,still kinda hard to start i think i need to lean it out a bit

 

[Fossil]

Don't lean it out too much at least until it is broken in.

 

[skyhawkcannondale]

You can fix her tommy .????????????????? right. We need to put a 302 on it,, lol lol lol.

 

[beentryin]

yeah ill figure it out always do