Motorized bicycle OVERSIZED TUBING solved

Discussion in 'Instructions for Building and Repairing Motorized ' started by wayde, Jan 20, 2008.

Thread Status:
Not open for further replies.
  1. wayde

    wayde New Member

    Joined:
    Jan 20, 2008
    Messages:
    23
    Likes Received:
    0
    here's how i took of this issue
     

    Attached Files:

  2. wayde

    wayde New Member

    Joined:
    Jan 20, 2008
    Messages:
    23
    Likes Received:
    0
    Re: OVERSIZED TUBING solved

    it actually is a 2 1/4 muffler clamp
     
  3. nogoodnic

    nogoodnic New Member

    Joined:
    Jan 29, 2008
    Messages:
    509
    Likes Received:
    0
    Re: OVERSIZED TUBING solved

    Here is how I did mine, I took a 7" peice of 1" flat stock and welded a short section of black 1" pipe cut in half to one end. Bent the flat stock to get the half round where it needed to be for propper mounting and used two muffler clamps to hold it to the frame...Kelly
     

    Attached Files:

  4. RedB66

    RedB66 New Member

    Joined:
    Dec 28, 2007
    Messages:
    1,023
    Likes Received:
    0
    Re: OVERSIZED TUBING solved

    I used U-Bolts on my install and they work well. I also used automotive fuel line, which comes in various diamiters, to kind of shroud the bolt
     

    Attached Files:

  5. deacon

    deacon minor bike philosopher

    Joined:
    Jan 15, 2008
    Messages:
    8,119
    Likes Received:
    0
    Re: OVERSIZED TUBING solved

    they make a heater hose in up to at least 1" diameter I think. I used it to wrap my undersized tube. Hard to believe there is actually a tube too small for this toy.
     
Thread Status:
Not open for further replies.

Share This Page