Gas tank builders

Kevlarr

Kevlarr

New Member
Ran across something you guys may find useful and it's a whole lot cheaper then the Ridley gas cap kit

Moroso 85282 Moroso Weld-In Fill Cap

710-85282.jpg


They also have them in billet aluminum.
 
very similar to the one used on my stretch's tank

azvinnie (my son-in-law) gets the locally for the same price
 

Attachments

  • mini-raw tank 009.jpg
    mini-raw tank 009.jpg
    92.2 KB · Views: 199
  • mini-raw tank 007.jpg
    mini-raw tank 007.jpg
    88.5 KB · Views: 180
They look to be about 3/4" right? Too bad there isn't something available that's closer to 1" - 1 1/2", well other then the pricey MC fill caps.
 
Go down the site page,there is a 1 1/2" one ,there are 3 choises and one of them seems to attatch to the tank in different ways (slightly higher price)
 
cheapest one i've found is to rip apart the kit tank. on most of them, the bung is pressed and sandwiched in (some older ones are welded, though.) you can cut and pry it right out, then silver solder it into your fancy new tank.

the cap still blows, though.
 
You must log in or register to reply here.
Back
Top