Flower nut hitting the inside of the case cover

GoldenMotor.com

Wevil Kenevil

Well-Known Member
Mar 4, 2022
318
297
63
47
Sack a tomatoes California
Am I correct to assume that when the clutch is disengaged (pulled) and the flower nut rubs the inside of the case that I can shorten the clutch shaft slightly by removing the clutch cable anchor bolt and tightening the ring nut around the clutch?

I do realize of course this would make my clutch much tighter.

Theoretically would this work?
 
  • Like
Reactions: fasteddy

Venice Motor Bikes

Custom Builder / Dealer/Los Angeles
Mar 20, 2008
7,271
1,810
113
Los Angeles, CA.
First, try going to the other side & tightening the nut that's holding the drive sprocket onto the clutch shaft. (that should pull the entire clutch assembly back to that side of the engine)

I use a small piece of chain doubled up on the sprocket to hold it while tightening the nut.