Cyclo spoke rolling threading tool..

[Mossy]

I found one for a decent price with a 10ga head and I found a few 12ga heads so I got on of those and still looking for an 11ga one... Because I was looking for spokes and there becoming limited on sizes so I can make my own from longer ones if needed...

 

[Mossy]

Just glad I've got this coming...
The hozan was more money and there's another one listed for $500 with some #8 and #9 dies... Wheel building essential I also found some spoke weights for balancing and some tires...

 

[Mossy]

Getting stuff cheaper from Australia now with there dollar dropping... 1/3 usa dollar... China beating the **** out of them... I get a bargain... Hopefully the war lasts until I get the rest of the tools...

 

[Mossy]

In an hour I hope I have another spoke roller in 9ga 3.5mm... with the 10 and 12 should have everything covered... The moped rims take a large spoke and nipple there also made so the spokes are angled aiming at the hub where the go... Where a bicycle rim the spokes bend around each other and any hole can get laced up with any spoke... There also no off set or one side of the hub larger than the other...

 

[Mossy]

8 minutes... Unless someone raises the bid 90pounds sterling...

 

[Mossy]

I got it... The bottom one is on its way...
9-10-12 ga... And 2 bases For $300... Obsolete except for the 12ga head... And that's new coming from Australia...
Even if I use it one time it's going to pay for itself... I might get another 12g head just for the rollers if there the same for all of them...

 

[Tony01]

That’s cool but I’m so done with spokes. Actually I like spokes wheels I just don’t like tubes. I really like the BMW wheels with the spokes outside of the bead.

 

[Mossy]

This came in... I'm hoping the rollers are the same size as the 9-10g ... So I can swap out new ones...