I'd like to get a CNC intake. I understand they seal better and perform slightly better than the stock one. Would like to get one that can connect a bigger carburetor. My bike currently tops out at about 37 with 32t sprocket. Would like to be able to get it at least a bit over 40 without having to to advanced stuff like crank balancing or messing with reeds. I have a mostly stock unported Samger 100cc engine. Any help is appreciated.
Can Somone recommend a good non reed intake?
- Thread starter Rusty_Nail
- Start date
A basic kit with all stock parts should be able to hit 40 mph with a little modifying and some tuning.
I would ditch the small sprocket & go back up to a 40t (so the engine will have more pulling power).
Next I would gut out the muffler & do a little port matching in the intake & exhaust manifolds, & then I would re-jet the stock carb. That should get you about 45 mph.
I would ditch the small sprocket & go back up to a 40t (so the engine will have more pulling power).
Next I would gut out the muffler & do a little port matching in the intake & exhaust manifolds, & then I would re-jet the stock carb. That should get you about 45 mph.
