jim trabulsi
New Member
Will the carb. cable on the motor kits reach to the handles of my 15 inch hi rise bars or do I need the beach bars?
cables for hi rise handlebars
- Thread starter jim trabulsi
- Start date
ocho ninja
Member
You can always make your own throttle cable.
Buy a long length of brake cable at the bike shop, and cut to desired length, make sure to cut the end with the smaller end and keep the bigger end for your throttle assembly.
For the end that goes into the carb slide, you can heat it up with a propane torch, apply a light coating of solder then wrap some thin copper wire, and apply more solder until you get the right blob size that fits in the slide.
If its too big you can always file it down.
hope this helps
Buy a long length of brake cable at the bike shop, and cut to desired length, make sure to cut the end with the smaller end and keep the bigger end for your throttle assembly.
For the end that goes into the carb slide, you can heat it up with a propane torch, apply a light coating of solder then wrap some thin copper wire, and apply more solder until you get the right blob size that fits in the slide.
If its too big you can always file it down.
hope this helps
runnermike
Member
A lot of the vendors on this site sell various lengths of throttle cable
There's no way we can answer that question without actually being there and trying it.
There are too many variables.
As was suggested you'll have to try it yourself then possible buy new cables or make your own. Any bicycle shop or even Wally World (WalMart) sells cables.
Tom
There are too many variables.
As was suggested you'll have to try it yourself then possible buy new cables or make your own. Any bicycle shop or even Wally World (WalMart) sells cables.
Tom
The_Aleman
Active Member
I had a similar problem with apehangers. Unlike some of the more industrious fellas here, I didn't make my own, I bought tandem cables.
A shifter cable for a tandem should work. If you're not making your own, take the cable to a bike shop to compare ends.
A shifter cable for a tandem should work. If you're not making your own, take the cable to a bike shop to compare ends.
SuperDave
Member
I use apehangers on my bike, and the 44" factory cable was barely long enough to reach the carb. When I installed an intake extension tube, I got a long 60" brake cable from my local bike shop, and some "Cable Stays" from my local auto supply house (look in the "Help" section, or ask a salesperson where the cable clamps for throttle cables are located). They are a lot like the clutch cable clamp that comes with a lot of these HT motors. I used the big end of the brake cable in the throttle grip, and after measuring & cutting, I used the 2nd smallest clamp (the smallest was too small of a hole to feed the cable) in the carb's throttle slide. And just to ensure it wouldn't rattle loose, not only did I use RED threadlock on the cable clamp screw, I also soldered over the end of the cable end with a big glob of solder. I always use solder on my cable ends to prevent them from fraying apart, not only does it make them last longer, it also looks nicer. Anyways, it worked for me, but your mileage may vary. I've been running mine for a few months with no problems, hasn't tried to pull apart or ingest the clamp or screw. I hope I never have to pull it apart, as the red threadlock is much stronger than the blue, but if I do I may end up having to use vice grips.
