66cc, M7 or M8?

DanielMaia

DanielMaia

New Member
Hey there guys!

Another engine i have here, and, one day..i just tighten too much a stud, resulting on a stripped off stud (we only learn by the bad way)

Im going to put a Helicoil..but have a doubt, it is M7 or M8? the stud it self it has 7.60mm, on the side of 1.0 thread. But the hole in the crankcase, has 6.6 or 6.7mm

What size of helicoil should i buy?
 
A Helicoil would restore the thread to its original size, therefore you have to drill and tap a hole oversize for the coil to go into it. I don't think that there is enough metal for an oversize hole. These engines use either a M6 or M8 stud, so recheck your measurements.
I think it is M6 and when the stud came out it ripped the threads so now you are measuring 6.6/6.7
 
You must log in or register to reply here.
Back
Top