2nd Build - Schwinn Clairmont with EZ Motorbike kit
- Thread starter abikerider
- Start date
abikerider
New Member
Yes, those Surly singulators are nice but pricey at around $50. I kept my derailleur but it does make it a pain in the but to remove the rear wheel.
I've had a few rear flats too. I finally used an old tire to line the inside of my tire for the ultimate in flat prevention. So far so good.
I've had a few rear flats too. I finally used an old tire to line the inside of my tire for the ultimate in flat prevention. So far so good.
abikerider
New Member
I decided to make a baffle for my tailpipe since it's a little too loud for me. After researching a little on the web I came up with this.
It's a 3/4" copper pipe that I put five cuts in with a hacksaw. Then I heated it to glowing and quenched it in a bucket of water to make the copper soft. I used a nail and hammer to punch in one side of each slit and it's done. It slides in snuggly and it fastened with a self tapping screw through the tail pipe and baffle. It makes my exhaust note a little less harsh.
It's a 3/4" copper pipe that I put five cuts in with a hacksaw. Then I heated it to glowing and quenched it in a bucket of water to make the copper soft. I used a nail and hammer to punch in one side of each slit and it's done. It slides in snuggly and it fastened with a self tapping screw through the tail pipe and baffle. It makes my exhaust note a little less harsh.