GoldenMotor.com
1/8th thick 1/2 wd flat stock 6" in length, drilled tapped @ 1/4x20 holes then shaped (Hammer n Anvil horn) to mate with fender.
fender fit, because the holes are tapped no underside nut is required.You must grind off with body grinder or cutoff with dremmel any xtra length to b
Fender fit top--- before this you gotta match up your tab to the slot on fender. and using a sharp punch n hammer punch the coresponding hole through
in vice holes drilled, tapped, tabs welded to spine.
1/8th thick 1/2 wd flat stock 6" in length, drilled tapped @ 1/4x20 holes then shaped (Hammer n Anvil horn) to mate with fender.
Tab- do the drilling/slotting before cutting to length. Far easier to hold on to.
allen standley

1/8th thick 1/2 wd flat stock 6" in length, drilled tapped @ 1/4x20 holes then shaped (Hammer n Anvil horn) to mate with fender.

There are no comments to display.

Media information

Album
Safe fenders
Added by
allen standley
Date added
View count
773
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Top Bottom