JNM Super Mount

C

chainganglowrider

New Member
Has anyone tried the JNM Super Mount ? I went go use one today as I needed to swap out my motor anyway, and noticed the holes are drilled too narrow in the rubber compared to the width of the studs. Anyone used one of these yet ?
FrontMount.jpg

RearMount.jpg

Curtis
 
Some of these engines are being drilled for for the larger frame tubes. It looks as if those mounts were made to fit the older (different) sized spacing.
 
Hay if you don't need that mount and studs I'll buy it off of you easy. I have the smaller mount but my engine won't fit my frame without them. I know where to get the but if I can help a fellow motorbiker get some green then I'll help.
 
Lucajo, This thread is over five years old.
Good luck. I hope you get a reply from the OP. He hasn't posted since.

Tom
 
lucajo16 said:
I doubt I'll get a responce but I posted my issue and I need those mounts if I can help it.
Click to expand...
Maybe try our 'Swap & Shop' section. Post it under WTB, 'want to buy' and see if another member can help you. Good luck.

Tom
 
You must log in or register to reply here.
Back
Top